Bornhardt, an engineer to the Grand Duke of
Brunswick.
This apparatus (shown in the accompanying engravings) consists
essentially of two hard-rubber disks, A (Figs. 2 and 3), keyed to an
iron axle, and of two rubbers, B, that are formed of skin and are held
against the disks by small springs, R; motion is communicated to the
axle, _a_, by means of a pair of gearings, _a_ and _b_, and a crank,
_f_.
[Illustration: BORNHARDT'S ELECTRIC MACHINE FOR BLASTING IN MINES.]
Each disk revolves between two metallic rings, _c_, provided with
points that attract and collect in Leyden jars, D, the electricity
produced by the friction. For discharging the condensers there is
employed a manipulator formed of a rod, mm, which can be acted upon,
from the exterior, by means of a button, _k_. Upon bringing the ball,
_m_, of the rod in contact with the ball, _p_, of the condenser, the
lever (which then takes the position shown by the dotted line)
continues to remain in connection with a small ring, _q_, through a
special spring. Another ring, _t_, is connected in the same way with
the external armature of the condenser. Upon connecting the rings, _p_
and _t_, by a wire to which cartridges are attached, any number of the
latter may be ignited.
The parts that we have just enumerated are inclosed in a tin box
covered with a wooden casing, P. Between the two there is inserted a
sheet of hard rubber in order to prevent a loss of electricity; the
whole is held in place by strong springs.
Pages:
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94