Prev | Current Page 100 | Next

Anonymous

"The New York Subway Its Construction and Equipment"

7 pounds of steam per electrical horse-power hour;
three-quarter load, 937-1/2 kilowatts, 16.6 pounds per electrical
horse-power hour; one-half load, 625 kilowatts, 18.3 pounds; and
one-quarter load, 312-1/2 kilowatts, 23.2 pounds. When operating under
the conditions of speed and steam pressure mentioned, but with a
pressure in the exhaust pipe of 27 inches vacuum by mercury column
(referred to 30 inches barometer), and with steam at the throttle
superheated 75 degrees Fahrenheit above the temperature of saturated
steam at that pressure, the guaranteed steam consumption is as
follows: Full load, 1,250 kilowatts, 13.8 pounds per electrical
horse-power hour; three-quarter load, 937-1/2 kilowatts, 14.6 pounds;
one-half load, 625 kilowatts, 16.2 pounds; and one-quarter load,
312-1/2 kilowatts, 20.8 pounds.
[Sidenote: _Exciter
Engines_]
The two exciter engines are each direct connected to a 250 kilowatt
direct current generator. Each engine is a vertical quarter-crank
compound engine with a 17-inch high pressure cylinder and a 27-inch
low-pressure cylinder with a common 24-inch stroke. The engines will
be non-condensing, for the reason that extreme reliability is desired
at the expense of some economy. They will operate at best efficiency
when indicating 400 horse power at a speed of 150 revolutions per
minute with a steam pressure of 175 pounds at the throttle. Each
engine will have a maximum of 600 indicated horse power.
[Sidenote: _Condensing
Equipment_]
Each engine unit is supplied with its own condenser equipment,
consisting of two barometric condensing chambers, each attached as
closely as possible to its respective low-pressure cylinder.


Pages:
88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112