CHAPTER II
TYPES AND METHODS OF CONSTRUCTION
Five types of construction have been employed in building the road:
(1) the typical subway near the surface with flat roof and "I" beams
for the roof and sides, supported between tracks with steel bulb-angle
columns used on about 10.6 miles or 52.2 per cent. of the road; (2)
flat roof typical subway of reenforced concrete construction supported
between the tracks by steel bulb-angle columns, used for a short
distance on Lenox Avenue and on the Brooklyn portion of the Brooklyn
Extension, also on the Battery Park loop; (3) concrete lined tunnel
used on about 4.6 miles or 23 per cent. of the road, of which 4.2 per
cent. was concrete lined open cut work, and the remainder was rock
tunnel work; (4) elevated road on steel viaduct used on about 5 miles
or 24.6 per cent. of the road; (5) cast-iron tubes used under the
Harlem and East Rivers.
[Sidenote: _Typical
Subway_]
The general character of the flat roof "I" beam construction is shown
in photograph on page 28 and drawing on this page. The bottom
is of concrete. The side walls have "I" beam columns five feet apart,
between which are vertical concrete arches, the steel acting as a
support for the masonry and allowing the thickness of the walls to be
materially reduced from that necessary were nothing but concrete used.
The tops of the wall columns are connected by roof beams which are
supported by rows of steel columns between the tracks, built on
concrete and cut stone bases forming part of the floor system.
Pages:
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51